
Then, I cut the sequin trim as close to the edge as I could without snipping any of the treading that holds them to the material.

Once the trim was off, I cut carefully at the seam so the sequin trim is in a long strip.
Then, I used the glue to adhere it to the bracelet, pressing down as I went. Once the sequin strip is around the bracelet one whole time I carefully lined it up & cut it so that the ends met perfectly. I reinforced the seam where they met with extra glue underneath. Also, I ran more glue around each edge so the sequin strip wasn't loose at all - no floppy edges!

And then, ta-da! Behold, super cute bangle bracelet with a do-it-yourself bent: